|
|
|
INFORMATION DETAILS
ID: 26961118
|
Year: 2024
|
Make: Lane Shark
|
Model: Hammerhead
|
Type: New
|
| MSRP:
N/A |
Engine Size - cc: N/A |
SELLER DESCRIPTION
COMPATIBILITY:
- Hydraulic implement flow rate 8.5gpm to 20gpm
- Must have a third function to operate. ONLY Pressure comes from the remote, and return must be to the sump. (CANNOT RETURN THROUGH AUXILIARY HYDRAULICS)
- NOT COMPATIBLE WITH DIVERTER VALVES
- Minimum dry tractor weight of 3000 lbs
- Minimum tractor width of 55 inches
- Must have certified roll over protection system
- For stabilization while operating the Lane Shark, fill rear tires of your tractor with water for use as a ballast, as well as additional weight on rear. ie: box blade, or rotary cutter.
|
Details:
- Fully hydraulically articulated - control cutting positions from the comfort of your tractor seat
- Hammerhead control switch box included
- Cutting width / cutting area of 44"
- Easily cuts up to 2-3” diameter limbs, brush, saplings, and underbrush. Cutting width is 44". The Hammerhead has a wide range of cutting positions that allow it to cut vertically, offset, directly in front (level), or 25°, 35°, & 45° in the vertical and offset positions
- The Lane Shark Hammerhead attaches to the front of any FEL tractor with a SSQA or JD Hook & Pin-Style attachment system. There are adapters available to fit most other applications sold separately.
- Rear rubber skirt and skid shoes for a smoother cutting process
- The Lane Shark Hammerhead weighs just under 550 pounds
- When purchasing the Lane Shark brush cutter, you will receive a unit equipped with #10 ORB (O-ring Boss) inlets. When using ORB, a minimum inside diameter of 1/2” is required.
- NOT COMPATIBLE WITH SKID STEERS
|
Back
|
|
|
|
Address:
